Our tint lasts for 4–6 weeks.

1. Mix 1cm of tint and 3 drops of cream developer into a dappen dish.
2. Prep skin by removing makeup and lining the brow arch and tail sides with Vaseline / Petroleum Jelly to act as a moisture barrier and prevent staining slips.
3. Gather the tint on a tint brush and apply it to the brows, making sure each hair is coated and shaped as desired.
4. Depending on the desired colour, leave tint on for 5–7 minutes; you can tell when it is time to remove it because you will see the colour set. For extra dark, leave it on for 10 minutes.
   If brows have been laminated:
   • For fine brows, leave the tint on for 3 minutes.
   • For healthy brows, leave for 4 minutes.
   • For coarse brows, leave for 5 minutes.
5. Remove with tint/makeup remover on a cotton pad.

1. Prep: remove any contact lenses, clean the eye area with lash cleanser and place biogel under eye pads underneath the lashes.
2. Immediately before tinting, mix 1cm of tint and 3 drops of cream developer into a dappen dish.
3. Apply to lashes using a tint brush.
4. Leave tint on for 10 minutes. If a lash lift has been performed:
   • For fine lashes, leave the tint on for 3 minutes.
   • For healthy lashes, leave for 4 minutes.
   • For coarse lashes, leave for 5 minutes.
5. Remove tint with a warm, moist cotton pad, wiping from the root down to the tips. Eyes must remain closed until the last trace of tint has been removed.

Lash Bomb Starter – to amend add the inclusion.

Apply a thin coat of lifting cream to the brow hair, making sure to apply closer to roots if you want brows to be set in the right direction after procedure, or to the entire hair if you want to soften thick hair and straighten curly strands.

• Processing time:
  • Very fine brows: 3–4 minutes
  • Fine or tinted brows: 4–5 minutes
  • Natural healthy brows: 5–6 minutes
  • Coarse healthy brows: 6–7 minutes
• Remove cream using a clean cotton bud

• Apply a small amount of neutralising lotion using a micro applicator (apply to the same place the lifting serum was applied)
• Processing time:
  • Very fine brows: 3–4 minutes
  • Fine for tinted brows: 4–5 minutes
  • Natural healthy brows: 5–6 minutes
  • Coarse healthy brows: 6–7 minutes
• Remove lotion using a clean cotton bud
• Carefully comb through with a brow brush
• Optional: if you have purchased tint separately, apply at this point

• Apply moisturising serum over the brows using a micro-applicator
• Explain aftercare to client and give them a printed copy to take away along with a spoolie